Chapter IV · Stabilisation and clarification
How wine becomes clear: how long yeast and lees take to settle (Stokes' law), which fining agent is used for what and at what dose (gelatin, egg white, casein, PVPP), and how to choose a filter and its area.
Stokes' law: v = (2/9)·(ρₚ − ρ)·g·r²/μ. Wine density ≈ 0.993 g/cm³; viscosity at 20 °C ≈ 1.0·(1 + 0.04·A) mPa·s, changing with temperature by Arrhenius (2320 K). Particles smaller than 1 µm are kept from settling by Brownian motion and convection (even small temperature differences): such wine no longer clears by itself.
The dose is always chosen with a bench trial: different doses in identical bottles, then after 1–3 days compare clarity, colour and taste. g/hL = grams per 100 litres (10 g/hL = 0.1 g/L). Egg white and casein are allergens: in the EU they must be declared on the label if residues remain in the wine.
Filter capacity (litres per m²) depends on turbidity: rough ≈ 1500, polishing ≈ 800, "sterile" depth ≈ 500 L/m² at 10 NTU; for a wine twice as hazy capacity falls ≈ 1.6 times (approximate). The useful area of a 20×20 cm sheet is ≈ 0.034 m², of a 40×40 ≈ 0.14 m². Flow rate ≈ 800 L/m²·h (rough) to 400 (sterile).
After fermentation wine is hazy: yeast cells, bacteria, particles of grape pulp, and colloidal aggregates of proteins and phenolics are suspended in it. Clarity is achieved in three ways: natural settling and racking, fining agents (which make particles larger) and filtration. Winemakers usually use all three in sequence: the better a wine settles, the less fining and filtration it needs.
A particle suspended in wine is acted on by gravity, Archimedes' buoyancy and viscous drag. Their balance gives a constant settling velocity (Stokes' law):
$$v = \frac{2}{9}\cdot\frac{(\rho_p - \rho)\,g\,r^2}{\mu}$$
where ρₚ is the density of the particle and ρ that of the wine, r is the particle radius and μ the viscosity of the wine. What matters most is r²: a particle twice as large settles four times faster, one ten times as large a hundred times faster.
| Particle | Size | Settling time over 0.6 m, 15 °C |
|---|---|---|
| Fining floc | ≈ 50 µm | hours |
| Yeast floc | ≈ 20 µm | ≈ 1 day |
| Yeast cell | 3–5 µm | 1–3 weeks |
| Bacterium | 0.5–1 µm | months to a year |
| Colloid | < 0.5 µm | practically does not settle |
Temperature affects settling in two ways: cold wine is more viscous (which slows it slightly), but in the cold convection currents weaken and particles stick together (flocculation), so in the end wine clears better in the cold. For particles smaller than 1 µm, Brownian motion and convection are stronger than gravity: they no longer settle by themselves. Such particles must either be enlarged (by fining) or removed with a filter.
In a tall vessel settling takes longer, because the particle has further to travel. In a qvevri the wine clears over the winter, for months, at a cool and stable temperature: ideal conditions for natural settling.
A fining agent is added to wine and forms large, heavy flocs with wine compounds (mainly tannins and phenolics), which settle quickly and carry suspended particles down with them. Protein fining agents (gelatin, egg white, casein, isinglass, plant proteins) are positively charged at wine pH and bind to negative tannins and colloids.
| Agent | Dose, g/hL | Wine | Purpose |
|---|---|---|---|
| Gelatin | 3–15 | red; white with tannin | softening astringency, clarification |
| Egg white | 5–15 (1–3 whites per 100 L) | red | gentle fining, balancing tannin |
| Casein, skimmed milk | 10–50 | white | removing brown colour and bitterness |
| PVPP | 10–80 | white, rosé | preventing phenolics and oxidation |
| Isinglass | 1–4 | white | brilliant clarity |
| Plant protein | 5–30 | all | vegan alternative |
| Bentonite | 20–100 | white | protein stabilisation (see previous page) |
g/hL means grams per 100 litres: 10 g/hL = 0.1 g/L. The dose of a fining agent is always chosen with a bench trial. Too high a dose "strips" the wine: it loses colour, tannin, aroma and body. Excess protein fining agent remains in the wine and later forms a haze (over-fining), which is why gelatin is used with tannin or silica sol in white wine.
Egg and milk proteins are allergens. In the EU they must be declared on the label if residues are detected in the wine. For vegan wine bentonite, PVPP, plant proteins and chitosan are used.
Filtration stops particles mechanically. There are two types of filter:
A depth filter (filter sheets, "pads") is a thick layer of cellulose fibres and diatomaceous earth that traps particles throughout its thickness. It holds a lot of particles, but its pore size is nominal: the sheet grade indicates approximately what size of particles it stops.
A membrane filter is a thin polymer film with precise, absolute pores (e.g. 0.45 µm). It reliably stops yeast and bacteria, but clogs quickly, so the wine must first be cleaned with a depth filter.
| Filtration | Pores | What it stops | When |
|---|---|---|---|
| Rough | 5–8 µm | lees, flocs | after racking |
| Polishing | 1–3 µm | most yeast cells | before bottling |
| "Sterile" | 0.45–0.65 µm | yeast and bacteria | when bottling wine with residual sugar |
Filter throughput depends on pressure, area and wine viscosity (Darcy's law): flow Q = ΔP·A/(μ·R), where R is the resistance of the filter and the layer built up on it. As filtration proceeds R rises and flow falls: the filter clogs. The hazier the wine, the less wine one square metre of filter passes, so the wine should settle well before filtration.
During filtration wine takes up oxygen (0.5–2 mg/L), and the first litres pick up the taste of the filter sheet, so sheets should first be rinsed with water (and then a little wine). Filtration slightly reduces body and aroma, the more so the finer the filter. Many winemakers, especially of qvevri wine, do not filter at all or use only rough filtration; for a dry, well-settled and stable wine this is entirely acceptable. For wine with residual sugar, however, "sterile" filtration (or potassium sorbate together with SO₂) is essential.
1. In the "Settling" mode choose a particle (or enter your own size and density), the liquid height in the vessel, the alcohol and the temperature. You will see the settling velocity, how long the particle will take to reach the bottom of the vessel, and the wine's viscosity. The chart shows settling time according to particle size, at your temperature and at 5 °C.
2. In the "Fining agents" mode choose the agent, dose and wine volume. You get the grams (for egg white, the number of eggs), an assessment compared with the typical range, and what it is used for. The chart shows the bench trial: how many millilitres of solution to put in each bottle.
3. In the "Filtration" mode choose the goal, wine turbidity, volume and filter size. You get the area needed, the number of sheets, the filtration time and advice.
1. For 225 litres of red wine take 3–5 egg whites (without the yolk).
2. Mix the whites with 0.5 litre of water and a small pinch (≈ 1 g) of salt: the salt helps dissolve the protein. Do not whisk into a foam; mix gently.
3. Pour the mixture slowly into the wine and stir it well through the whole volume.
4. Leave for 1–3 weeks, then carefully rack the wine off the lees.
1. Make a 1% solution of the fining agent: gelatin, 1 g in 100 mL of warm (40 °C) water; casein, 1 g in 100 mL of water with a little potassium carbonate; PVPP, 1 g in 100 mL of water (a suspension).
2. Pour an accurately measured volume of wine into 5 identical bottles. Add the calculated amount of solution with a syringe; the first bottle is the control.
3. After 1–3 days compare: clarity, colour, aroma, taste (tannin, astringency). Choose the smallest dose that gave the result you want.
• The most common home filter is a small plate filter (3 sheets of 20×20 cm) with a pump. Sheets come in three grades: rough, polishing and "sterile".
• Before filtration let the wine settle well and rack it. A hazy wine will clog the sheets within minutes.
• First flush the sheets with 10–20 litres of clean water, then run through a couple of litres of wine: this way the cardboard taste of the sheets does not pass into the wine.
• Run the filter outlet hose to the bottom of the receiving vessel so the wine does not splash. Fill the vessel with CO₂ beforehand if possible.
• If the pressure rises sharply and the flow drops, the filter is clogged: change the sheets.
• After "sterile" filtration bottle the wine the same day into sterilised bottles: the filter only protects the wine if it is not contaminated again afterwards.
1. By Stokes' law, if the particle diameter is halved, how many times slower does it settle?
Settling velocity is proportional to the square of the radius: a particle half the size settles four times more slowly. That is why yeast flocs settle in days, but single bacteria in months or not at all.
2. Why is wine fined with protein (gelatin, egg white)?
Protein and tannin attract each other. The flocs also sweep down suspended particles. But too high a dose "strips" the wine, taking away colour and structure.
3. Why is 0.45 µm filtration especially important for a semi-sweet wine?
A yeast cell is 3–5 µm, a bacterium ≈ 1 µm; a 0.45 µm filter stops both. A wine with residual sugar needs either this, or potassium sorbate and SO₂, or both.