Winemaking Laboratory
Fruit wines / Body, tannin and colour

Chapter IX · Fruit wines

Body, tannin and colour

The body and structure of red grape wine come from skin and seed tannin, extract and glycerol, and its colour from anthocyanins, which form polymeric pigments with tannin that last for years. Fruit wine often lacks all of this: dilution lowers extract and tannin, and without tannin the anthocyanins break down quickly and the colour "fades" within months.

Tannin balance

Tannin with illustrative values, expressed in phenolic equivalents. Wine tannin ≈ juice tannin × juice share. 1 g/hL of oenological tannin ≈ 10 mg/L (ignoring the preparation's purity); typical doses are 5–30 g/hL, more only after a trial, since bitterness and astringency can become excessive. The blend share is that of the fruit juice that brings tannin to the target.

Tannin in wine—mg/L
Deficit—mg/L
Oenological tannin—g/hL
Or blend—%

Wine parameters

Illustrative model: sugar-free extract ≈ the fruit's non-sugar soluble solids × juice share + glycerol; glycerol ≈ 8% of the ethanol mass (alcohol × 7.9 × 0.08 g/L). For comparison, sugar-free extract in white grape wine is usually 17–22 g/L, in red 25–32. The balancing sweetness is an empirical estimate: the higher the acidity, the more residual sugar the wine "carries".

Sugar-free extract—g/L
Glycerol—g/L
Body—
Balancing sweetness—g/L

Colour and storage

Illustrative model. Share of the coloured (flavylium) form = 1/(1 + 10^(pH − 2.6)); SO₂ partly bleaches anthocyanins (bisulphite adduct). Free anthocyanins degrade as A(t) = A₀·e^(−kt), k ≈ 0.12 month⁻¹ at 15 °C (Q10 ≈ 2); part of them, in proportion to the amount of tannin, turns into stable polymeric pigments that are less sensitive to pH and SO₂.

Colour now—index
Colour at 12 months—index
Polymeric pigments—%
Coloured form—%

Tannins in fruit

Tannins are polyphenols that bind to proteins and thereby cause astringency. Fruit contains two main groups:

• Condensed tannins (proanthocyanidins): polymers of flavan-3-ols (catechin, epicatechin). These are the tannins of grapes, apples, quinces, pears and blackcurrants.
• Hydrolysable tannins (ellagitannins): esters of gallic or ellagic acid with glucose. The main tannin of pomegranate is punicalagin, that of raspberry and blackberry sanguiin H-6; oak tannin belongs to the same group.

Tannin gives wine structure, protects it from oxidation and takes part in colour stabilisation. Most fruits contain moderate amounts, and after dilution less than 100–200 mg/L may remain in the wine, the level of a white grape wine. Red grape wine usually contains 1–3 g/L of phenolics.

How to make up tannin

1. Oenological tannin: ready-made preparations of gallotannins (from gall nuts), ellagitannins (oak, chestnut) and condensed tannins (grape seed and skin, quebracho). The dose is usually 5–30 g/hL (1 g/hL = 10 mg/L). Higher doses can be bitter and coarse, so a small bench trial is needed first.
2. Blending with tannic fruit: pomegranate, blackcurrant, quince, cornelian cherry. This adds tannin "naturally", but also changes aroma and acidity.
3. Skin maceration: fermenting on the pulp increases tannin and colour, but in pectin-rich fruit also methanol (see "Pectin and methanol").
4. Oak: barrels or oak pieces add ellagitannins and aroma (see "The oak barrel").

The tannin deficit is calculated as:

$$D = T_{target} - T_{juice}\cdot s,\qquad \text{dose [g/hL]} = D/10$$

where s is the juice share in the must. The blend share x that brings tannin to the target follows from the same balance: $x = (T_{target} - T_1)/(T_2 - T_1)$.

Body and extract

The "body" of a wine is the sum of several components: alcohol, glycerol, sugar-free extract (acids, salts, phenolics, polysaccharides, proteins) and residual sugar. Sugar-free extract is usually 17–22 g/L in white grape wine and 25–32 g/L in red. In fruit wine, especially after dilution, it is often below 15 g/L.

Glycerol is a by-product of fermentation, usually 7–10% of the ethanol mass, i.e. 7–9 g/L in a 12% wine. Its formation increases with temperature and with certain yeast strains. Ageing on lees also adds body (mannoproteins, see "Lees ageing").

Balancing acidity and sweetness

Many fruit wines are semi-dry or semi-sweet: sweetness reduces the perception of acidity and "fills in" low extract. The calculator's balance estimate is empirical:

$$RS_{bal} \approx 3\cdot(TA - 5)\ \text{g/L}$$

i.e. ~6 g/L of residual sugar at 7 g/L acidity and ~15 g/L at 10 g/L. This is a starting point; the final dose is set by tasting. The wine's category is defined by EU Regulation 2019/33 (see "Taste perception").

A wine with residual sugar is microbiologically unstable: fermentation can restart in the bottle. So stabilisation is needed: enough free SO₂, potassium sorbate (in the EU ≤ 200 mg/L as sorbic acid) or sterile filtration.

Colour: the chemistry of anthocyanins

The colour of red fruit comes from anthocyanins. Grapes contain mainly malvidin glucosides, while other fruits contain other anthocyanidins: cyanidin in blackberry and sour cherry, delphinidin and cyanidin rutinosides in blackcurrant, and delphinidin, cyanidin and pelargonidin 3,5-diglucosides in pomegranate. Malvidin's methoxylated B ring makes it more stable than cyanidin and delphinidin, which is one reason the colour of fruit wine "fades" faster.

An anthocyanin exists in solution in several forms. The red flavylium cation is in equilibrium with water and the colourless hemiketal:

$$x_{flav} = \frac{1}{1 + 10^{\,\mathrm{pH} - pK_h}},\qquad pK_h \approx 2.6$$

So at pH 3.4 only ~14% of the anthocyanins are coloured, and at pH 3.8 ~6%. Low pH strengthens and brightens the colour. SO₂ (bisulphite) forms a colourless adduct with the flavylium and partly bleaches the colour of young wine.

How colour becomes stable

Free anthocyanins gradually break down (hydrolysis, oxidation), especially at high temperature. The main route to colour stability is condensation with tannins: the anthocyanin binds to tannin directly or through an acetaldehyde "ethyl bridge" and forms a polymeric pigment. Such pigments are less sensitive to pH, are not bleached by SO₂ and last for years. So to keep the colour of fruit wine, the following matter equally:

• enough tannin (from the fruit, a blend or oenological tannin);
• low pH (3.2–3.5);
• cool storage: every 10 °C roughly doubles the rate of anthocyanin breakdown;
• moderate SO₂ and protection from oxygen.

The calculator's kinetic coefficients (k ≈ 0.12 month⁻¹ at 15 °C, polymerisation share T/(T + 600)) are illustrative; they show trends, not an exact forecast.

Sources

R. S. Jackson, Wine Science (Academic Press); P. Ribéreau-Gayon et al., Handbook of Enology, vol. 2, phenolic compounds; A. L. Waterhouse, G. L. Sacks, D. W. Jeffery, Understanding Wine Chemistry (Wiley, 2016); R. Brouillard, J.-E. Dubois, flavylium cation equilibria (J. Am. Chem. Soc., 1977); M. N. Clifford, Anthocyanins: nature, occurrence and dietary burden (J. Sci. Food Agric., 2000); M. I. Gil et al., antioxidant activity of pomegranate juice and punicalagin (J. Agric. Food Chem., 2000); EU Regulations 2019/33 and 2019/934. The tannin and anthocyanin figures for fruits are illustrative.

How to use this page

1. In the "Tannin" mode, choose a fruit and the juice share in the must (shown on the "Preparing fruit must" page), the desired style and a tannic fruit for blending. The cards show the wine's tannin, the deficit, the oenological tannin dose, and how much juice of the other fruit to blend in to bring tannin to the target.

2. In the "Body and balance" mode, enter the juice share, Brix, alcohol, acidity and residual sugar to get the sugar-free extract, glycerol, body category and a residual-sugar guide that balances the acidity.

3. In the "Colour stability" mode, choose a red fruit, pH, free SO₂, storage temperature and wine tannin: the chart shows how colour changes over 24 months in your option, with extra tannin and in a cool cellar.

Examples

• Pear, juice share 60%: ~150 mg/L of tannin in the wine. A medium style (400 mg/L) needs 25 g/hL of oenological tannin, or ~33% pomegranate juice.

• Quince wine, acidity 10 g/L: ~15 g/L of residual sugar to balance it, so the wine will be semi-dry.

• Blackberry, pH 3.4, 300 mg/L tannin, 15 °C: ~⅔ of the colour remains after 12 months; more with +500 mg/L tannin or storage at 10 °C.

Practical tips

• Add oenological tannin at the start of fermentation: this way it integrates better and also takes part in colour stabilisation.

• Stabilise wine with residual sugar before bottling (SO₂ + sorbate, or sterile filtration); do not add sorbate after malolactic fermentation, as a geranium smell may appear.

• Store red fruit wine cool and dark, and drink it young if it has little tannin.

1. Why does blackberry wine lose colour faster than Saperavi?

Colour stability depends on the condensation of anthocyanins with tannin. Saperavi has plenty of both; in fruit wine, especially after dilution, tannin is often insufficient.

2. What does sugar-free extract mean?

Extract is the dry residue of the wine (acids, salts, phenolics, glycerol, polysaccharides). Sugar is subtracted so that sweet and dry wines can be compared.

3. Why is some residual sugar often left in fruit wines?

Sweetness reduces the perception of acidity and adds body. A wine with residual sugar, however, needs stabilisation (SO₂, sorbate, sterile filtration) so that fermentation does not restart in the bottle.