Chapter IX · Fruit wines
Pectin is the "glue" of cell walls: its chains give fruit its firmness, while in wine they cause viscosity, haze and poor filterability. Breaking pectin down increases juice yield, but one of the enzymes, pectin methylesterase, releases methanol at the same time. Controlling methanol is one of the main technological tasks in fruit winemaking.
The model is illustrative. Methanol potential = pectin × degree of esterification × 168.5 mg/g (fully esterified pectin contains 16.3% methoxyl). The released fraction R = 1 − e^(−kt); k depends on the enzyme, temperature (Q10 ≈ 2) and pH (PME is less active in acidic conditions). When juice is fermented, only ~40% of the pectin takes part, since most of it is in the skin. Limits: OIV, 250 mg/L for white and rosé and 400 mg/L for red grape wines.
The model is illustrative: yield Y = Y₀ + (Y_max − Y₀)(1 − e^(−k·D·t)), where D is the dose and k increases with temperature (Q10 ≈ 2), while above 50 °C the enzyme denatures. A typical dose is 2–4 g per 100 kg of fruit (follow the manufacturer's instructions exactly). Methanol rises together with yield; see the first mode.
Methanol from the same fruit under seven process options (same model, temperature 20 °C). The results are illustrative, but the trends match the literature: commercial pectinase brings methanol close to its maximum, fermenting juice and removing skins roughly halves it, and acidity and short contact limit PME.
Pectin is a cell-wall polysaccharide. Its main part, homogalacturonan, is a long chain of galacturonic acid molecules (α-1,4 linked). Some of the carboxyl groups of these acids form ester bonds with methanol, the so-called methoxyl groups. The share of esterified groups is called the degree of esterification (DE); in fruit pectin it is usually 55–80%. Pectin makes up about 0.3–1.5% of the fruit's mass: there is a lot in quince, apple, plum, apricot and blackcurrant, little in sweet cherry, pomegranate and mulberry. Most of it is in the skin and the tissue under the skin.
Pectin causes two problems in wine. First, it increases viscosity and makes juice extraction difficult: crushed fruit holds its juice like a jelly. Second, pectin is a protective colloid: it keeps suspended particles from settling, so the wine stays hazy and filters poorly.
Pectin is broken down by three main enzymes:
1. Pectin methylesterase (PME) hydrolyses the methoxyl groups: the chain remains, but methanol is released.
2. Polygalacturonase (PG) cuts the de-esterified chain; it needs PME to act first.
3. Pectin lyase (PL) cuts the esterified chain directly and releases no methanol.
PME is naturally present in fruit, and yeast and other microorganisms also secrete it. Commercial pectinases are mixtures of these enzymes; most of them also contain PME, so they increase methanol along with juice yield. There are also low-PME preparations, in which the chain is cut mainly by pectin lyase.
The maximum amount of methanol that can be released from pectin is set by its methoxyl content. In fully esterified pectin the methoxyl group (OCH₃) is 16.3% of the mass, so:
$$M_{max} = P\cdot DE\cdot 0.163\cdot\frac{32.04}{31.03} \approx P\cdot DE\cdot 168.5\ \text{mg/g}$$
where P is pectin (g/kg of fruit) and DE the degree of esterification (as a fraction). For example, plums with 9 g/kg of pectin and DE 0.7 give a methanol potential of ~1060 mg per kilogram. If ~14 L of wine is obtained from 20 kg of plums, the maximum is ~1500 mg/L.
The fraction actually released depends on PME activity and contact time. The calculator describes it with first-order kinetics:
$$R(t) = 1 - e^{-kt},\qquad k = (k_{PME} + k_{enz})\cdot 2^{(T-20)/10}\cdot f(\mathrm{pH})$$
The coefficients are illustrative and chosen so that the trends match the literature.
There is little methanol in grape wines, because grapes contain little pectin: 120–250 mg/L in reds and 40–120 mg/L in whites, with more in reds because of longer skin contact. Freshly squeezed, unpasteurised fruit juices also contain ~140 mg/L of methanol on average (12–640 mg/L). Fruit wines reach much higher values: experimental plum wines in Serbia had more than 1000 mg/L.
The OIV limit (OENO 19/2004) for grape wines is 400 mg/L for reds and 250 mg/L for whites and rosés. The EU sets separate limits for fruit spirits (1000–1350 g per hectolitre of pure alcohol), because methanol is concentrated by distillation. The grape-wine limits can serve as a benchmark for fruit wine.
In the body, methanol is oxidised by alcohol dehydrogenase to formaldehyde and formic acid, and it is these products that damage the optic nerve and cause acidosis. Ethanol competes for the same enzyme and slows the oxidation of methanol, so methanol at natural levels in wine poses no acute danger. According to the FIVS review, the reference level for a single exposure is 20 mg/kg of body weight, i.e. 1400 mg for a person weighing 70 kg. The main danger is distilling fruit wine: in fruit brandy, methanol is concentrated in the heads.
Research on fruit spirits (Lachenmeier's review) points to the following measures:
• Do not use PME-containing pectinase during long fermentation on the pulp. Commercial enzymes raise methanol to its potential maximum; in some trials it was 5–6 times higher than without enzyme.
• If the wine style allows, ferment the juice rather than the pulp; removing the skins roughly halves methanol.
• Shorten skin contact and do not leave crushed fruit standing for long before fermentation starts.
• Acidic conditions (low pH) limit PME activity; PME has its optimum in neutral to alkaline conditions (pH ~8, 50 °C).
• Pre-heating the fruit (blanching) inactivates PME, although it changes the aroma.
• Overripe fruit can give less methanol in some cases, but rotten and damaged fruit gives more.
• Fermentation temperature: in one study of apricot wine, fermentation at 18 °C gave significantly less methanol than at higher temperatures.
The presence of pectin in wine is checked with a simple test: 3–4 parts of 90–96% ethanol are added to one part of wine in a test tube and shaken. If jelly-like flakes or strands appear within a few minutes, the wine contains soluble pectin and needs pectinase treatment before clarification. In this case a low-PME preparation is better: little pectin is left undegraded, and the methanol increase will also be small.
OIV, Resolution OENO 19/2004 "Maximum content limits of methanol in wines"; FIVS, Methanol in Wine (2016) and OIV Congress 2017 (BIO Web of Conferences 9, 02028); D. W. Lachenmeier et al., Methanol Mitigation during Fruit-Spirits Manufacturing (Foods, 2021); optimisation of plum wine fermentation (Serbia, 2014, FAO AGRIS); a study of fermentation temperature and pectin-degrading enzymes in apricot wine (Zhongguo Niangzao); OIV, International Oenological Codex, determination of PME activity. The pectin content of fruits and the calculator's kinetic coefficients are illustrative.
1. In the "Methanol" mode, choose a fruit (pectin and degree of esterification fill with typical values), and enter the amounts of fruit and water, the process, contact time, temperature, pH and enzyme. The cards show the methanol potential, the released fraction and the expected amount in the wine; the chart shows accumulation over time for your option, without enzyme and with PME-containing pectinase.
2. In the "Pectinase and yield" mode, choose a fruit, the enzyme dose, temperature and time to get the juice yield, the extra juice, the degree of pectin breakdown and the time for breakdown to reach 90%.
3. In the "Comparing strategies" mode, choose a fruit and amount: the chart compares the same fruit under seven process options.
• Plum, 20 kg, 5 L of water, 7 days on the pulp, 20 °C, no enzyme: ~620 mg/L, above 400 mg/L. With PME-containing pectinase: ~1100 mg/L.
• The same plums, pressed juice without enzyme: ~250 mg/L.
• Pomegranate (little pectin): most options are below 250 mg/L.
• Add pectinase only when it is really needed: to extract juice (a short treatment, a few hours) or to remove pectin haze after fermentation.
• Be especially careful with plum, apricot, quince and apple wine: these fruits are rich in pectin.
• Do not distil fruit wine at home without analysis: methanol is concentrated in the spirit.
• Pectin test: 1 part wine + 3–4 parts 90–96% ethanol; jelly-like flakes mean pectin remains.
• This model is illustrative. The exact amount of methanol can only be determined by laboratory analysis (gas chromatography).
1. Where does methanol in fruit wine come from?
The carboxyl groups of galacturonic acid in pectin are partly esterified with methanol. PME breaks this ester bond and methanol is released. So the amount of methanol depends on the fruit's pectin and on enzyme activity.
2. Which option gives the most methanol?
Most of the pectin is in the skin, and most commercial pectinases also contain PME. Together they bring methanol close to its maximum potential.
3. Why does pectinase improve clarification of wine?
Pectin chains are a protective colloid that keeps haze particles in suspension. Once the chains are broken, viscosity drops and the particles settle.