Chapter VI · Modern technology and ageing
In pressing the cleanest juice comes out first, and then, as the pressure rises, the juice from near the skins and seeds, with a higher pH, more potassium and more phenolics. How to divide the juice into fractions, how to build a press cycle, and how much press wine to blend back into a red.
The model is illustrative. Maximum juice yield: pneumatic ≈ 0.78, basket ≈ 0.72, screw ≈ 0.82 L/kg. Free run: ≈ 60% of all juice when crushed, ≈ 20% with whole bunches. As the pressure rises the pH increases (≈ +0.2–0.3 in the last fraction), and phenolics rise several-fold. Fraction limits are in % of all juice. For comparison, in Champagne 4000 kg yield 2050 L of cuvée and 500 L of taille.
At each step the juice yield approaches the equilibrium value for that pressure exponentially (τ ≈ 4 min); between steps the membrane deflates and the drum rotates to break up the pomace cake. Many slow low-pressure steps give better juice than fast high pressure. A typical cycle: 1.5–2 h for crushed grapes, 2.5–4 h for whole bunches.
After the maceration of a red wine ≈ 80–85% free-run wine drains from the pomace and pressing gives a further ≈ 10–15%. Press wine has more tannin, colour, higher pH and often more volatile acidity. The properties of the blend are volume-weighted averages. Keep the fractions separate and blend after tasting. The EU limit for volatile acidity is 18 meq/L for white and 20 meq/L for red (≈ 1.08 and 1.20 g/L as acetic acid).
Pressing is the mechanical separation of liquid from grapes or pomace. For white wine the grapes are pressed before fermentation; for red, the pomace is pressed after fermentation and maceration. In qvevri winemaking the pomace is traditionally pressed after racking, and the press wine is either kept separately or used for chacha.
The juice of a grape berry is not uniform. The middle of the pulp, around the seeds, contains the most sugar and acid; the cells under the skin have less acid, more potassium, more aroma compounds and more phenolics. When a berry bursts, the pulp juice comes out first (free run), and as the pressure rises the juice from near the skin and from the skin cells themselves follows.
The juice obtained in pressing is therefore divided into fractions:
1. Free run: juice released without pressure. The cleanest, least phenolic and most acidic.
2. First press fraction (in Champagne, the cuvée): juice released at low pressure. Similar in composition to the free run and combined with it.
3. Second fraction (taille): at higher pressure; richer in pH, phenolics and aroma, but less delicate.
4. Last pressings: juice released at high pressure; bitter, phenolic, high in pH. Often fermented separately or used for distillation.
| Fraction | pH | Phenolics | Use |
|---|---|---|---|
| Free run | lowest | fewest | the finest white and sparkling wine |
| Cuvée | +0–0.05 | few | the same |
| Taille | +0.1–0.15 | moderate | fuller-bodied wine, blending |
| Last pressings | +0.2–0.3 | many | separate, or distillation |
Under Champagne rules only 2550 L of juice may be taken from 4000 kg of grapes: 2050 L of cuvée and 500 L of taille (≈ 0.64 L/kg). The rest is kept separate. This is a limit set for quality: the maximum juice yield is ≈ 0.75–0.80 L/kg.
The reason for the rise in pH is potassium. The skin cells are rich in potassium; potassium binds tartaric acid as potassium bitartrate, which lowers the amount of free acid (see Chapter II "Acids and pH"). Wine from the last fractions is therefore less microbiologically stable, SO₂ is less effective in it, and its colour is less stable.
• Basket (vertical) press: a wooden or steel cylinder into which a piston descends from above. The juice passes through a thick layer of pomace that acts as a filter, so the juice is clean. Slow and labour-intensive.
• Pneumatic (membrane) press: a horizontal drum in which a rubber membrane inflates with air and presses the grapes gently against the wall. The pressure is low (0.2–2 bar); between steps the drum rotates and breaks up the pomace cake. Closed models work under inert gas and rule out oxidation. The modern standard for white wine.
• Continuous screw press: the pomace is moved and pressed continuously by a screw. High throughput, but the juice is phenolic and cloudy. In quality winemaking it is used mainly for chacha or for the last fraction.
For sparkling and light white wine the grapes are often pressed uncrushed, as whole bunches. The stems form channels for the juice, the berries burst gradually and the juice has less contact with the skins. The juice obtained has fewer phenolics, less colour (crucial when making white wine from red grapes) and fewer solids. The price is a slower cycle and a smaller press load.
During one step the juice yield approaches the equilibrium value for that pressure roughly exponentially:
$$x(t) = x_{eq}(P) - \bigl(x_{eq}(P) - x_0\bigr)\,e^{-t/\tau},$$
where $\tau$ is a few minutes. The equilibrium yield rises with pressure and saturates, $x_{eq}(P) = x_{fr} + (1 - x_{fr})\,(1 - e^{-P/P_0})$, where $x_{fr}$ is the free-run share. High pressure adds little extra yield in the last percent while sharply lowering quality. A good programme therefore consists of several slow, low-pressure steps, with the pomace broken up between them.
After the maceration of a red wine ≈ 80–85% free-run wine drains from the pomace, and pressing yields a further ≈ 10–15%. Press wine has more tannin, colour and pH and, because the pomace cap is in contact with air, often more volatile acidity. In moderate amounts it adds structure. To a first approximation, the properties of the blend are volume-weighted averages:
$$C_{mix} = \frac{V_f C_f + V_p C_p}{V_f + V_p}.$$
The fractions should be kept separate and blended after tasting.
P. Ribéreau-Gayon et al., "Handbook of Enology", vol. 1 (pressing, white and red winemaking); R. Boulton et al., "Principles and Practices of Winemaking"; Comité Champagne, Champagne pressing rules (4000 kg, 2550 L). The fraction composition model is illustrative and varies with the grapes, variety and press.
1. In the "Fractions" mode, enter the amount of grapes and the free-run pH, choose the press and the loading method, and set the cuvée and taille limits with the sliders. The cards show the volume, mean pH and phenolics of each fraction. The chart shows how pH and phenolics rise towards the end of pressing.
2. In the "Press cycle" mode, enter the load, the maximum pressure, the number and duration of the steps. You will see the cycle time, the juice yield, the flow, and how much juice the last, highest-pressure step gives.
3. In the "Press wine" mode, enter the volume, tannin and volatile acidity of the free-run and press wine, and the target tannin. Use the slider to choose how much of the press wine to blend in. The calculator tells you how much press wine is needed to reach the target.
• Taste the juice, or measure its pH, at every step of pressing. When the juice becomes bitter and phenolic, change the fraction.
• For white wine, press cool grapes, with a small dose of SO₂ and as little contact with air as possible.
• In a basket press, load the pomace in layers, with straw or stems if needed, so that the juice drains easily.
• Keep press wine in a separate vessel. It often develops well and can be blended in after tasting.
• Use the last pressings for chacha.
The fraction model is illustrative. For your own grapes, measure the pH and, if possible, phenolics or A280 in each fraction.
1. How does the juice pH change during pressing as the pressure rises?
Juice released from the skin cells and the pulp next to them contains more potassium and less free acid. Potassium binds tartaric acid as bitartrate, so the last fractions have a higher pH.
2. Why are grapes for sparkling wine pressed as whole bunches?
In an intact bunch the stems form drainage channels and the berries burst gently. The juice has less contact with the skins, so it contains fewer phenolics and less colour, which matters for white and sparkling wine, especially from red grapes.
3. Which press programme gives better juice?
At low pressure the juice comes mainly from the pulp. High pressure crushes skins and seeds and adds phenolics, turbidity and bitterness. Breaking up the pomace cake opens new channels for the juice.