Chapter IX · Fruit wines
Grapes are a naturally "balanced" raw material: enough sugar for 12–14% alcohol and moderate acidity. Most fruits are not: blackberries and raspberries lack sugar, cornelian cherries and cherry plums have too much acid, and persimmons have almost none. That is why fruit-wine must is prepared: diluted with water, with sugar and, where needed, acid added.
Typical juice values (illustrative): Brix, titratable acidity (g/L as tartaric), pH, juice yield and tannin. Variety, ripeness and year change them widely; for exact numbers measure your own juice. Sugar: S ≈ 0.92·10·Brix·ρ (fruit has ~8% non-sugar soluble solids), potential alcohol = S/17.
If the juice acidity is above the target, the calculator dilutes with water until the acidity reaches the target and makes up the missing sugar with sucrose (1 kg of sucrose ≈ 0.62 L of volume and 1.05 kg of hexose). If the acidity is low, it adds no water and adds acid instead. Target acidity in fruit wines is usually 5–8 g/L and alcohol 10–13%. Heavy dilution weakens the aroma.
The sugar and acidity of the blend are volume-weighted averages of the juices. The pH is estimated from the weighted average of hydrogen ions; this is a rough approximation, because buffer systems interact on mixing (see "Fruit acids").
Grapes are an almost ideal raw material for wine: ripe grape juice contains 200–250 g/L of sugar, enough for 12–14% alcohol, acidity is 5–9 g/L, pH 3.1–3.6, and there is enough nitrogen and tannin. Other fruits rarely reach this balance. The differences fall into four groups:
1. Sugar: most fruits have 8–15 °Bx, i.e. 4–9% potential alcohol. Such a wine is weak and microbiologically unstable.
2. Acidity: in some fruits (cornelian cherry, cherry plum, blackcurrant) it reaches 25–30 g/L, in others (persimmon, mulberry, pear) it drops to 2–4 g/L. The acid composition also differs: grapes are dominated by tartaric and malic acid, other fruits by malic or citric acid, and blackberries also contain isocitric acid (see "Fruit acids").
3. Pectin: there is much more of it in fruit; it hampers juice extraction and clarification and is a source of methanol (see "Pectin and methanol").
4. Tannin and colour: plentiful in pomegranate and blackcurrant, scarce in pear and peach (see "Body, tannin and colour").
Typical juice values are given below. They are illustrative and vary widely with variety, ripeness and year: for example, the acidity of pomegranate juice ranges from about 2 to 35 g/L (as malic acid) depending on the variety. So Brix and acidity must be measured for every batch (see "Measuring tools and tests").
| Fruit | °Bx | Acidity, g/L (as tartaric) | pH | Main acid |
|---|---|---|---|---|
| Apple | 12 | 7 | 3.5 | malic |
| Pear | 12 | 3.5 | 3.9 | malic, citric |
| Quince | 9 | 13 | 3.4 | malic |
| Pomegranate | 15 | 12 | 3.3 | citric, malic |
| Cherry plum | 10 | 25 | 2.9 | malic |
| Sour cherry | 15 | 17 | 3.4 | malic |
| Blackberry | 10 | 12 | 3.2 | isocitric, malic |
| Raspberry | 10 | 20 | 3.2 | citric |
| Cornelian cherry | 13 | 30 | 2.9 | malic |
| Persimmon | 18 | 2 | 5.6 | malic |
Brix is the mass fraction of soluble solids. In grapes about 90% of it is sugar; in other fruits the share of non-sugar substances (acids, pectin, salts) is larger. The calculator estimates sugar as:
$$S \approx 0.92\cdot 10\cdot \mathrm{Brix}\cdot\rho,\qquad \rho \approx 1 + 0.004\cdot\mathrm{Brix}$$
where S is sugar in g/L and ρ the juice density. About 17 g/L of sugar is needed for 1% alcohol (16.5–18, depending on the yeast and fermentation conditions), so potential alcohol ≈ S/17.
Sugar is usually added as sucrose. The yeast's invertase splits it into glucose and fructose; water is taken up in the hydrolysis, so 1 kg of sucrose gives 1.053 kg of hexose. Dissolved sucrose also adds volume, about 0.62 L per kilogram. This is not negligible: 4 kg of sugar increases the must volume by 2.5 litres and dilutes the acidity accordingly.
Dilution does not change the mass of sugar and acid, only the volume. If the juice volume is $V_j$, its sugar $S_j$ and acidity $A_j$, and the targets are $S_t$ and $A_t$, then:
$$V = \frac{A_j V_j}{A_t},\qquad m = \frac{S_t V - S_j V_j}{1050},\qquad W = V - V_j - 0.62\,m$$
where V is the final must volume (L), m the sucrose (kg) and W the water (L). For example, 15 L of blackberry juice (12 g/L) must be diluted to 27.7 L to reach 6.5 g/L; 12% alcohol then needs 4.0 kg of sugar and 10.2 L of water.
If the acidity is below the target (persimmon, mulberry, pear), no water is added; instead, acid has to be added. If the juice acidity is very high (cornelian cherry, cherry plum), the dilution exceeds 50% and the aroma of the wine weakens. In that case it is better to blend with another fruit (the calculator's "Fruit blend" mode) or to reduce the acidity chemically (see "Fruit acids").
Acidity is measured by titration and expressed as the equivalent of one acid; we use tartaric acid throughout. When another acid is added, its mass is converted by the ratio of equivalent masses: tartaric acid 75 g/eq, malic 67, anhydrous citric 64. So 1 g of tartaric-acid equivalent requires 0.89 g of malic or 0.85 g of citric acid. Citric acid is easily broken down by bacteria (diacetyl, volatile acidity), so it is avoided when malolactic fermentation is planned.
Fruit juices often contain little yeast-assimilable nitrogen (apple juice about 50–150 mg/L), and dilution reduces it further. So fruit must often needs yeast nutrient (diammonium phosphate, yeast extract), otherwise fermentation may stick or a hydrogen-sulphide smell may appear (see "Preparing the must for fermentation", mode "Yeast and nitrogen").
The stones of apricots, cherries, sour cherries and plums contain amygdalin, whose breakdown releases hydrogen cyanide. So these fruits are processed without cracking the stones, or the stones are removed, and long maceration with crushed stones is avoided.
R. S. Jackson, Wine Science: Principles and Applications (Academic Press), chapter on fruit wines; WineMaker Magazine, on the acidity of fruit wines (mid-range fruit acidity values); A. C. Hulme (ed.), The Biochemistry of Fruits and their Products (1971); H. McGee, The Curious Cook (table of fruit sugar and acid); pomegranate juice composition: Hasnaoui et al., International Journal of Food Properties (30 Tunisian accessions); USDA FoodData Central. The table values are illustrative.
1. In the "Fruit table" mode, choose a fruit: the cards show its typical sugar, acidity, pH and potential alcohol. The chart places all fruits by sugar and acidity, the colour shows pH, and the green rectangle marks the ripe-grape zone. You can change how the table is sorted.
2. In the "Must calculation" mode, choose a fruit (the fields fill with typical values), enter the mass of fruit and, if you measured them, your own Brix and acidity. Set the target alcohol and acidity, and the calculator works out the water, sugar, acid and must volume.
3. In the "Fruit blend" mode, choose two or three fruits and their masses to get the blend's sugar, acidity and a rough pH estimate.
• Blackberry, 20 kg, 0.75 L/kg, 10 °Bx, 12 g/L → 12% and 6.5 g/L: 10.2 L of water, 4.0 kg of sugar, 27.7 L of must.
• Persimmon, 20 kg, 18 °Bx, 2 g/L → 12% and 6.5 g/L: no water, 0.3 kg of sugar and ~46 g of tartaric acid.
• Apple 10 kg + quince 5 kg: the quince adds acidity and aroma to the blend, the apple adds sugar and juice.
• Do not rely on the table: measure the juice Brix with a refractometer and the acidity by titration, because the same fruit changes a lot from year to year.
• Add the sugar in portions: first half, the rest during the first days of fermentation; this way the yeast suffers less osmotic stress.
• Add acid little by little and taste after each addition: must tastes sweeter than wine, and acid comes across more sharply against alcohol.
• The water must be clean and chlorine-free; if you use tap water, boil and cool it first.
• Because of its low nitrogen, fruit must usually needs yeast nutrient.
1. Blackberry juice has 12 g/L acidity. By how much must it be diluted to bring acidity to 6 g/L?
Dilution does not change the mass of acid: 12·V = 6·V′, so V′ = 2V. One litre of water is added to each litre of juice, and the sugar must be made up accordingly.
2. Why is sugar almost always added to fruit must?
A 10 °Bx juice gives ~5% potential alcohol. Such a wine is not stable, so about 17 g/L of sugar is added for each extra percent.
3. Persimmon juice is almost acid-free (pH ~5.6). What is the main risk?
Above pH 3.6 the share of molecular SO₂ drops sharply and the wine becomes microbiologically unstable. That is why tartaric or citric acid is added to low-acid fruit.