Winemaking Laboratory
Modern technology and ageing / Modern maceration techniques

Chapter VI · Modern technology and ageing

Modern maceration techniques

The colour and tannin of red wine come from the skins and seeds, and their extraction is controlled by temperature, time, alcohol and mixing of the cap. Alongside classic maceration, modern winemaking uses cold soak, rack-and-return (délestage), extended maceration, thermovinification, flash détente and carbonic maceration.

Technique and conditions

The same extraction model as on the "Phenolics" page (illustrative, Q10 = 2). Parameters: cold soak, 5 days at 8 °C; délestage, extraction rate ×1.4; extended, a further 20 days after fermentation; thermovinification, 70 °C for 1 hour, then pressing and liquid-phase fermentation at 20 °C; flash détente, 90 °C for ≈ 15 min with vacuum (cells burst, rate ×10); carbonic, whole berries under CO₂ for 8 days at 30 °C, then pressing. The "days" field has no effect for thermovinification and flash.

Anthocyanins at the end—mg/L
Tannin—g/L
Seed tannin share—%
Skin contact—days

Conditions

All techniques with the same grapes and fermentation temperature. Anthocyanins give colour, tannin gives structure and astringency. Seed tannin dissolves as alcohol accumulates and is coarser, so its share matters. Thermal methods give strong colour and soft skin tannin; extended maceration gives a lot of tannin and less, but more stable, colour.

Most colour—
Most tannin—
Softest tannin—
Tannin / anthocyanins—

Tank and pump

Mixing the cap keeps the concentration gradient between skins and liquid, cools the cap and protects it from drying out and from acetic bacteria. The effect saturates: pumping over more than 1–2 tank volumes a day adds little extraction (model: factor = 1 + 0.6·(1 − e^(−V/V₁)), V₁ = 1 tank per day). An open pump-over gives the wine ≈ 1–3 mg/L of oxygen, useful for the yeast early in fermentation but not at the end. In délestage all the liquid is drained, the cap settles into a pomace cake, and the liquid is then returned over it all at once.

Pump time—min
Pumped per day—×
Extraction factor—×
Oxygen—mg/L

Maceration

Maceration (skin contact) is the transfer of substances from the solid parts of the grape (skins, seeds and stems) into the wine. The colour of red wine comes entirely from the anthocyanins of the skins, and tannin comes from the skins and seeds. The rate and outcome of extraction depend on four factors:

1. Temperature: every 10 °C roughly doubles the rate ($Q_{10} \approx 2$), and at high temperature the membranes of the skin cells break down.

2. Time: anthocyanins come out in the first 4–6 days, tannin much more slowly and over a long time.

3. Alcohol: seed tannin, covered by a waxy coat, dissolves as alcohol accumulates.

4. Mixing: punching down or pumping over the cap keeps the concentration gradient between skins and liquid.

The anthocyanin concentration reaches a maximum in 5–8 days and then falls: anthocyanins form polymeric pigments with tannins, adsorb onto the skins and yeast lees, and some break down. Tannin, on the other hand, keeps rising for a long time. The length of maceration is therefore a question of balancing colour and structure.

Techniques

TechniqueWhat happensResult
Classicfermentation on skins at 25–30 °C, 7–14 days, with cap mixingbaseline colour and tannin
Cold soak3–7 days at 5–10 °C before fermentation, then classicmoderately more colour and fruit aroma
Rack-and-return (délestage)all the liquid is drained, the cap settles, the liquid is returned at onceintense extraction, aeration, removal of some seeds
Extendedafter fermentation the wine stays on the skins for another 2–6 weeksmore, more polymerised tannin, fewer anthocyanins
Thermovinificationthe pomace is heated to 60–75 °C for 0.5–2 h, then presseda lot of colour, soft tannin, fruity style
Flash détenterapid heating to 85–95 °C, then vacuum: the cells burstvery much colour and skin tannin, fast production
Carbonicwhole berries under CO₂ for 5–15 daysintracellular fermentation, banana and berry aroma, soft wine

The traditional Georgian method, fermentation and maturation on the skins in qvevri, is in effect a form of extended maceration that is also used for white grapes (see Chapter V "The Kakhetian method").

Extraction model

The calculator uses the same kinetic model as the "Phenolics" page. For each source

$$\frac{dE}{dt} = k\,Q_{10}^{(T-25)/10}\,f\,(E_{max} - E) - k_{loss}E,$$

where $f$ is the mixing or cell-disruption factor. Anthocyanin extraction is fast and tannin extraction slow, while the rate for seed tannin grows with fermentation progress: $k_{seed} = k_0 + k_1\,\varepsilon^{1.5}$, where $\varepsilon$ is the degree of fermentation. For this equation, a technique is a sequence of temperature, time and $f$. For example, thermovinification is one hour at 70 °C with a large $f$, after which the pomace is removed, so there is a lot of colour and little seed tannin.

Cap management

During fermentation CO₂ lifts the pomace to the surface and forms a dense cap. If the cap is not mixed it dries out, heats up (see Chapter V "Fermentation in qvevri") and becomes a breeding ground for acetic bacteria, while the liquid beneath it loses contact with the skins.

• Punch-down (pigeage): the cap is pushed down by hand or with a pneumatic plunger. Gentle and effective, for small tanks and qvevri.

• Pump-over (remontage): liquid from the bottom of the tank is pumped over the cap. An open pump-over gives the wine oxygen, which helps the yeast early in fermentation.

• Rack-and-return (délestage): all the liquid is drained into another tank, the cap settles into a pomace cake, and after a few hours the liquid is returned over it all at once. Some seeds can be removed during draining.

The effect of mixing saturates. Pumping over 1–2 tank volumes a day raises extraction significantly; more adds little and gives the wine coarse tannin, solids and excess oxygen.

Sources

P. Ribéreau-Gayon et al., "Handbook of Enology", vol. 1 (red winemaking, thermovinification, carbonic maceration); K. Sacchi, L. Bisson, D. Adams, "A review of the effect of winemaking techniques on phenolic extraction in red wines", American Journal of Enology and Viticulture 56 (2005); R. Boulton et al., "Principles and Practices of Winemaking". The model numbers are illustrative and vary with variety, ripeness and vessel.

How to use this page

1. In the "Technique over time" mode, choose a technique, the fermentation temperature and the days on skins. The chart shows how anthocyanins and tannin change over time, with classic maceration under the same conditions as a dashed line. The cards show the final colour, tannin, seed tannin share and the length of skin contact.

2. In the "Comparing all techniques" mode, set the fermentation temperature and days. The bars show skin and seed tannin, the diamonds anthocyanins. The cards tell you which technique gives the most colour, the most tannin and the softest tannin.

3. In the "Cap management" mode, enter the tank volume, pump flow, method and frequency of mixing. You will see the pump time, the volume moved, the extraction factor and the oxygen.

Practical tips

• For a light, fruity red: short maceration at moderate temperature (22–25 °C), or carbonic maceration.

• For a structured wine for ageing: 28–30 °C at the fermentation peak and extended maceration, tasting the tannin every day.

• Do not extend maceration if the seeds are not ripe (green, bitter seeds). Some seeds can be removed during délestage.

• Do open pump-overs in the first half of fermentation and switch to punch-downs or closed pump-overs towards the end.

• Thermovinification and flash détente need special equipment and are used mainly in large-scale production.

The model numbers are illustrative. Tasting is the best measure: taste every day and press when the tannin reaches the level you want.

1. Why does thermovinification give a lot of colour and relatively little tannin?

Anthocyanins dissolve well in water and come out quickly from heat-damaged skins. Extracting seed tannin needs alcohol and time, whereas in thermovinification the pomace is pressed before fermentation.

2. What does a cold soak give?

At low temperature, before fermentation starts, extraction is slow and only water-soluble compounds come out. The effect is moderate and shows mainly in colour and fruit aroma.

3. Why is very frequent pumping over not useful?

The purpose of mixing is to keep the gradient between skins and liquid. Once the liquid is well mixed, more mixing hardly raises extraction, while the mechanical stress damages skins and seeds.