Winemaking Laboratory
Sensory science and tasting / Taste perception

Chapter VII · Sensory science and tasting

Taste perception

On the tongue the taste of wine is made of five basic sensations (sweet, sour, bitter, salty and umami), and in the mouth astringency, the "heat" of alcohol and body are felt. These sensations mask and balance each other: sugar softens acid, acid sharpens tannin, alcohol adds sweetness. How to assess the balance of a wine with numbers.

Wine analysis

Relative sweetness (sucrose = 1): fructose ≈ 1.3, glucose ≈ 0.7, glycerol ≈ 0.5; alcohol raises perceived sweetness (here ≈ +0.2 g/L equivalent per % vol above 10%). Residual sugar = glucose + fructose + sucrose. Label category under EU rules (Reg. 2019/33): dry ≤ 4 g/L, or ≤ 9 if acidity (as tartaric) ≥ sugar − 2; medium dry ≤ 12, or ≤ 18 if acidity ≥ sugar − 10; medium sweet ≤ 45; sweet > 45. The "perceived style" from the sugar-to-acid ratio, adjusted for pH, is a simplified guide.

Perceived sweetness—g/L
Sugar / acid—
Label (EU)—
Perceived style—

Phenolics and matrix

Astringency arises when tannins precipitate salivary proteins: the mouth "dries" and "puckers". It is increased by tannin and low pH (tannin is sharper in acidic wine) and reduced by sugar, polysaccharides and mannoproteins (they "shield" the tannin), and by tannin polymerisation during ageing. Bitterness comes from flavan-3-ol monomers and alcohol; sweetness masks it. The indices are illustrative: 1 ≈ noticeable, 2 ≈ strong, 3+ ≈ harsh.

Astringency—
Bitterness—
Alcohol "heat"—
Balance—

The "body" of wine

Body (fullness) is linked to the viscosity of the wine, alcohol, sugar, glycerol and dry extract (non-volatile substances: acids, phenolics, polysaccharides, minerals). The viscosity model is approximate: water 1.0 mPa·s at 20 °C, ethanol ≈ +4.5% per % vol, glycerol ≈ +0.23% and sugar ≈ +0.28% per g/L, temperature ≈ −2.5% per °C. A change in viscosity is only perceived from ≈ 20–25%, so 10 g/L of glycerol hardly changes body; alcohol and extract matter more. Typical extract: white 17–22, amber 22–28, red 25–32 g/L.

Viscosity—mPa·s
Body—
Glycerol contribution—
Alcohol—

Taste and mouthfeel

What we usually call "taste" is the joint result of three systems:

1. Taste: the taste buds of the tongue and mouth, which perceive five basic sensations: sweet, sour, bitter, salty and umami.

2. Tactile (somatosensory) sensations: astringency, viscosity, temperature, the "prickle" of CO₂, the "heat" of alcohol.

3. Retronasal smell: aroma rising from the mouth into the nose when swallowing. This makes up most of "flavour": the "taste" of fruit, wood or flowers is really smell.

Sweetness

The sweetness of wine comes mainly from residual sugar, glucose and fructose. Their sweetness differs:

SubstanceRelative sweetness (sucrose = 1)In wine, g/L
Fructose≈ 1.2–1.70–150
Sucrose1.0usually 0 (in dosage)
Glucose≈ 0.6–0.70–100
Glycerol≈ 0.55–12
Ethanolenhances perceived sweetness80–120

During fermentation yeast consumes glucose faster, so fructose predominates in the residual sugar, and the wine tastes sweeter than its sugar content would suggest. Even in dry wine, glycerol and alcohol give a little sweetness.

Acidity and balance

Sourness is determined jointly by hydrogen ions ($pH$) and titratable acidity. Acid and sweetness mask each other: the same sugar is less noticeable in an acidic wine. This is reflected in the EU labelling rules (Reg. 2019/33):

CategoryResidual sugar, g/L
Dry≤ 4, or ≤ 9 if acidity ≥ sugar − 2
Medium dry≤ 12, or ≤ 18 if acidity ≥ sugar − 10
Medium sweet≤ 45
Sweet> 45

(Acidity as tartaric acid, g/L.) To assess perceived style, the sugar-to-acid ratio is often used with a pH adjustment: a high-pH wine tastes less sour and therefore sweeter.

Astringency

Astringency is not a taste but a tactile sensation. Tannins bind and precipitate the proline-rich proteins of saliva; the saliva loses its lubricating ability and the mouth "dries" and "puckers". Astringency is:

• increased by tannin concentration, low pH, low temperature and the size of tannin molecules (galloylated seed tannin is coarser);

• reduced by sugar, polysaccharides and mannoproteins, alcohol (moderately), and polymerisation of tannins with anthocyanins (ageing).

Bitterness

Bitterness comes mainly from flavan-3-ol monomers and small oligomers (catechin, epicatechin) and from alcohol. The same compound can be both bitter and astringent; polymerisation lowers bitterness while astringency rises up to a point. In white qvevri wine made on the skins, a light bitterness and astringency are part of the style.

Body

Body (fullness) is the sensation of the "weight" of wine in the mouth. It is created by alcohol, dry extract (acids, phenolics, polysaccharides, minerals), sugar and glycerol. The viscosity of wine is ≈ 1.5–2 times that of water, mainly because of alcohol. Contrary to a common belief, the "tears" (legs) of wine on the glass are a result not of glycerol but of the Marangoni effect, a difference in surface tension caused by the evaporation of alcohol, and they mainly indicate alcohol.

Sources

R. S. Jackson, "Wine Tasting: A Professional Handbook", 3rd ed. (2017); A. L. Waterhouse, G. Sacks, D. Jeffery, "Understanding Wine Chemistry" (2016), on tannin and astringency; H. Heymann, S. Ebeler (eds.), "Sensory and Instrumental Evaluation of Alcoholic Beverages" (2017); EU Regulation 2019/33 (sweetness categories); International Riesling Foundation, Riesling Taste Profile. The calculator indices are illustrative.

How to use this page

1. In the "Sweetness and acidity" mode, enter glucose, fructose, sucrose, glycerol, titratable acidity, pH and alcohol. You will see the perceived sweetness (as sucrose equivalent), the sugar-to-acid ratio, the EU label category and the perceived style. The chart shows the label category boundaries and your wine.

2. In the "Astringency and bitterness" mode, enter tannin, pH, residual sugar, polysaccharides and alcohol. You will see indices for astringency, bitterness and alcohol "heat" and an assessment of balance. The chart shows how astringency changes with pH ±0.3.

3. In the "Body" mode, enter alcohol, glycerol, sugar, sugar-free extract and temperature. You will see the viscosity and its components, the body index and the real contribution of glycerol.

Practical tips

• In a dry wine, a few g/L of residual sugar balances high acidity: an old technique for white wine.

• An overly astringent red softens with time; protein fining agents (gelatine, egg white) reduce tannin quickly (see Chapter IV).

• When tasting, hold the wine in your mouth for half a minute: astringency and bitterness develop slowly, sweetness quickly.

• The "tears" of a wine indicate alcohol, not quality.

The indices are illustrative: people perceive the same wine differently.

1. Why can a wine with 8 g/L of sugar be "dry" under EU rules?

EU regulation allows an acidic wine to be labelled "dry" with up to 9 g/L of sugar if the titratable acidity is no more than 2 g/L below the sugar. This reflects a rule of perception: acid balances sweetness.

2. What reduces the astringency of tannin?

These substances compete with salivary proteins for the tannin or "shield" it. Low pH, on the contrary, makes tannin sharper.

3. Why does glycerol (≈ 8–10 g/L) not noticeably change the body of wine?

To change viscosity noticeably, glycerol would need to be ≈ 25 g/L. Body is set more by alcohol, sugar and dry extract. Glycerol adds a little sweetness.